Allied Manta Installationsanleitung PDF herunterladen (Seite 33)

AVT Manta cameras: installing hardware and software

Manta Hardware Installation Guide V4.1.0

Connecting camera to PC or laptop

1. Insert one end of the CAT-5e (or better) Ethernet cable into your Gigabit

Ethernet network card.

2. Insert the other end of the CAT-5e (or better) Ethernet cable into your

GigE camera.

3. Connect the external power supply to the GigE camera and check that

the camera is powered.

– You can power the camera via I/O connector or

– You can power the camera via PoE (must comply with IEEE 802.3at).

Start AVT UniCam Viewer application and

configure IP settings

1. Start the AVT UniCam viewer: Start  All Programs  Allied Vision

Technologies  Universal Package  AVT UniCam Viewer

Your GigE camera should appear in the list of cameras in the viewer

application. This may take a few seconds.

2. Optional: Configure IP settings manually: Again double-click the net-

work connection corresponding to the network card that was just

installed. In the list of items select Internet Protocol (TCP/IP) and

Caution



• Use only DC power supplies with insulated power

pins. These are identified by having only two power

connectors.

Note



The following description refers to the AVT Universal

Package with AVT UniCam Viewer.

For description of GigE sample viewer see Chapter Using the

GigE Sample Viewer on page 37.

Note



It may take some time for your GigE camera to be recognized

by the host computer.

• If your GigE camera doesn’t appear in the viewer appli-

cation’s list after 1 minute, reset your GigE camera by

disconnecting and re-connecting the power.

• If it still doesn’t appear, restart the viewer application.

• If it still doesn’t appear, read Chapter Troubleshooting

on page 54ff.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 60 61

Keine Kommentare

Allied Manta Installationsanleitung Seite 33