Allied Manta Installationsanleitung PDF herunterladen (Seite 34)

AVT Manta cameras: installing hardware and software

Manta Hardware Installation Guide V4.1.0

click Properties. You can see the automatically obtained IP address.

Take over this IP address by choosing Use the following IP address and

click OK.

3. Optional: Open the IP settings from AVT UniCam viewer: Right-click

desired GigE camera and choose IP

settings or in menu click on Camera

 IP

settings. Take over the IP address/Subnet mask from your camera

list. Choose Use the following Persistent IP address, enter this IP

address/Subnet mask and click OK.

4. Check exposure time and gain. You should now see an image.

Figure 13: Using Persistent IP address for camera

Note



Background: Automatic acquiring of an IP address may take

some time (up to one minute). To shorten this time, you can

manually enter IP address for your Gigabit Ethernet network

card and also for your GigE camera as described above.

If you want to enter IP addresses manually without getting

IP address automatically before, you need knowledge about

your network (DHCP server, APIPA) and knowledge of private

IP addresses. For more information read

Chapter Trouble-

shooting on page 54ff.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 60 61

Keine Kommentare

Allied Manta Installationsanleitung Seite 34